forum.alglib.net

ALGLIB forum
It is currently Sat Oct 01, 2022 3:46 pm

All times are UTC


Forum rules


1. This forum can be used for discussion of both ALGLIB-related and general numerical analysis questions
2. This forum is English-only - postings in other languages will be removed.



Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: BLEIC stopping criteria in v3.7.0 vs v3.6.0
PostPosted: Wed Feb 27, 2013 1:40 am 
Offline

Joined: Tue Jul 06, 2010 8:00 pm
Posts: 21
I am running an extensive optimization (see the "BLEIC performance in v3.7.0 vs v3.6.0" thread for details).

With v3.6.0, my stopping criteria were: EpsG=1e-6, EpsX=0, EpsF=0, EpsO = EpsI = 1e-6, MaxIts=0 (as suggested in the BLEIC user guide and examples). At the expense of a longer calculation time, I could even make EpsG=1e-7 and the termination type in the result record was always 4 ("conditions on constraints are fulfilled with error less than or equal to EpsC").

With v3.7.0, I noticed that EpsG has to be significantly increased for the termination type to be 4 ("gradient norm is no more than EpsG"); otherwise, the termination type is 7 ("stopping conditions are too stringent, further improvement is impossible, X contains best point found so far").
In the worst-case scenario, I had to increase EpsG to 5e-6 (with N+1 linear constraints) or even 8e-6 (with N boundary and 1 linear constraints).
Therefore, there is no way to increase the accuracy of any solution in my set by lowering EpsG below these levels, even if more calculation time was allotted.

While I understand that the BLEIC algorithm has been improved in v3.7.0 to handle special cases, it looks like it requires much higher levels of EpsG and, consequently, may not yield as accurate a solution as in v3.6.0.

Comments?


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group