forum.alglib.net • View topic - Uknown error message from 2Dbuildbicubic and/or 1dbuildakima

View unanswered posts | View active topics

Board index » ALGLIB forum » ALGLIB-discuss

All times are UTC

Forum rules

1. This forum can be used for discussion of both ALGLIB-related and general numerical analysis questions
2. This forum is English-only - postings in other languages will be removed.

Uknown error message from 2Dbuildbicubic and/or 1dbuildakima

Page 1 of 1

[ 1 post ]

Print view

Previous topic | Next topic

Author

Message

Marco

Post subject: Uknown error message from 2Dbuildbicubic and/or 1dbuildakima

Posted: Sat Feb 02, 2019 5:00 pm

Joined: Sat Feb 02, 2019 4:28 pm
Posts: 1

Hi,
I'm receiving the following error message from my Delphi IDE
(see attachment)
My code heavily use the 2d bicubic and 1d akima interpolation outines.
The error occurs consistently after a few hundreds (perhaps thousands) of calls.
Is there a reason for this?
ALso, the function tabulations must be at least of N points? what N would be?
Thanks for any help.
Kind regards
Marco

Attachments:

Alglib_uknown_error_1dbuildakima_errorCode.JPG [ 50.03 KiB | Viewed 10488 times ]

Alglib_uknown_error_2dbuildbicubic.JPG [ 23.63 KiB | Viewed 10488 times ]

Top

Page 1 of 1

[ 1 post ]

Board index » ALGLIB forum » ALGLIB-discuss

All times are UTC

Who is online

Users browsing this forum: No registered users and 93 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum