Hi,
I'm receiving the following error message from my Delphi IDE
(see attachment)
My code heavily use the 2d bicubic and 1d akima interpolation outines.
The error occurs consistently after a few hundreds (perhaps thousands) of calls.
Is there a reason for this?
ALso, the function tabulations must be at least of N points? what N would be?
Thanks for any help.
Kind regards
Marco
| Attachments: |
|
Alglib_uknown_error_1dbuildakima_errorCode.JPG [ 50.03 KiB | Viewed 4878 times ] |
|
Alglib_uknown_error_2dbuildbicubic.JPG [ 23.63 KiB | Viewed 4878 times ] |