forum.alglib.net
http://forum.alglib.net/

Uknown error message from 2Dbuildbicubic and/or 1dbuildakima
http://forum.alglib.net/viewtopic.php?f=2&t=3939
Page 1 of 1

Author:  Marco [ Sat Feb 02, 2019 5:00 pm ]
Post subject:  Uknown error message from 2Dbuildbicubic and/or 1dbuildakima

Hi,
I'm receiving the following error message from my Delphi IDE
(see attachment)
My code heavily use the 2d bicubic and 1d akima interpolation outines.
The error occurs consistently after a few hundreds (perhaps thousands) of calls.
Is there a reason for this?
ALso, the function tabulations must be at least of N points? what N would be?
Thanks for any help.
Kind regards
Marco

Attachments:
Alglib_uknown_error_1dbuildakima_errorCode.JPG
Alglib_uknown_error_1dbuildakima_errorCode.JPG [ 50.03 KiB | Viewed 2243 times ]
Alglib_uknown_error_2dbuildbicubic.JPG
Alglib_uknown_error_2dbuildbicubic.JPG [ 23.63 KiB | Viewed 2243 times ]

Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/